Waterline/Hull Tape

Similar to Go-Fast, the colours in Waterline are butt joined together-without any gap.

Sizes:
27mm x 10m
39mm x 10m

Also available in 50m rolls.

Standard Combinations:-
Dark blue/Mid blue/Light blue
Dark blue/Silver/Dark blue
Dark blue/Gold/Dark blue
Red/White/Mid blue
Red/Orange/Yellow
and Mariner in B39 only
Maroon/Dark red/Light red & Orange

Directions to apply all decorative stripes:
Do not apply stripes to any newly painted or varnished surface, this must be fully cured before application.
Ensure the application surface is clean, dry and free from dust and grease. Peel away the backing paper approximately 5cm and position the stripe at the start of the desired line. Unwind and apply to the hull in about 25cm lengths peeling away the backing paper as you do so. As you position the tape, apply gentle pressure to remove any creases and air bubbles. At this stage, it is possible to lift and reposition the stripe taking care not to stretch the tape. Carefully cut each end to the required length using a sharp knife and cutting away from the hull by taking the stripe to the blade. Use a soft cloth to firmly rub over the stripe to ensure a good bond and again, remove any remaining air bubbles. To finish, slowly remove the oversize carrier film where applied.